Your next step is to cut your PVC pipe as necessary so that when the PVC pipes are connected, you will have one run of PVC the same length as your measured distance. If your pool is curved, you need to mark all the sides and edges carefully. Using a crayon, mark the pool sides on your cover. With the help of another person or multiple people, if you have a larger pool, lay your cover across your pool with the bubble side facing down. Step 2 - Mark the Pool Sides on the Cover Measure your swimming pool at its longest point and widest point in case your pool is shaped other than a rectangle. Next, measure the width of the pool for the size of the tarp. Measure the length of the pool and add six inches to the measurement for the PVC, more if you are unsure about your skill level and want a little extra wiggle room. It is nearly impossible to find a cover that fits your pool perfectly, and therefore you will need to cut the cover to the right size after purchasing it. Your measurements need to be as accurate as possible. Using a measuring tape, measure the size of your pool before purchasing a cover to fit over it. This will help you determine how much materials you need for your project before you do anything else. The first step is to take measurements of your pool. You can also do this outside of the winter months if your pool just isn't heating up as much as you would like on its own. Laying it onto the pool at night during the winter months will prevent heat loss and help keep your pool relatively clean from debris. The bubbles on the bottom side resemble bubble wrap and retain the heat from the sun to keep the water warm and prevent evaporation (allowing people to enjoy their swimming pool even after the pool season has ended). Also called solar blankets, they are usually blue in color and made from polyethylene. Why Use a Solar Pool CoverĪ cost-effective way to enjoy a nice warm pool without installing a heat pump is to put a DIY solar pool cover over it. It is not expensive or time-consuming to do and can actually be quite environmentally friendly compared with some of the pool covers on the market as well. Bench options cannot be used on flus track applications.You can make a solar pool cover yourself by following these few easy steps to follow.If your pool cover bench will be more than 1′ from the swimming pools edge then the track length must be longer.įlush Deck Mounted – Before Ordering – Please Make Sure!.If you have stone or brick pool coping, then the cover track width must be made wider.The pool cover track length must be a minimum 1-1/2′ longer than the pool on each end.The pool cover must extend 2′ – 3′ from the deep end when using the bench options.The pool cover track width must be a minimum 3″ wider than the pool on each side.The pool cover track must be a minimum of 1′ past the step if step is outside the perimeter of the pool.The pool cover track width (x) the track length equals the pool covers square footage.Standard Deck Mounted – Before Ordering – Please Make Sure! Sturdy aluminum lid that provides easy access to system components (in ground only).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |